Thanks! A few more questions/concerns if you don't mind (I'm just playing devil's advocate).
Is there a reason why the PSU mounts are slots and not full holes? Also, have you thought about including mounting points for the PSU's bottom mounts (ones that are on that protruding piece at the opposite end of where the fan is). If you pause Linus' video at 10:20, you see how the PSU is bending the frame when the case is on its side, I think bottom mounts might help with that when the case is fully assembled. Finally, could you include regular flat screws for the PSU instead of thumbscrews? Thumbscrews are not great for portability, they can catch stuff when putting the case in/out of a backpack.
Any chance in the next revision you can address OptimumTech's concerns about countersunk screws and the side panels' corners not being perfect 90 degree angles? I think you commented on countersunk screws a while ago and said your tooling didn't allow it, but is there really nothing that can be done? It would look so much better.
Sorry that was a lot of questions... I have OCD