Case feet: there will be small rubber adhesive feet, most likely a pack of 12. They are removable but can sometimes leave some residue behind that should be wiped off.
---
Magnetic side panels: To have magnetic side panels, either the side panels or the case body would have to be made powder-coated steel instead of anodized aluminum. I think that this would cheapen the case since powder-coating is inferior to anodizing in virtually all regards except for being less expensive and being able to achieve a white color. This leaves two options:
1) If demand ever becomes high enough, create a separate steel variant of the case colored white to set it apart.
2) Offer an add-on kit consisting of magnetic strips and steel side panels colored white or black. The body will remain anodized silver, gray, or black, and a color match between anodized and powder-coated parts is impossible. This would allow for two-toned cases like silver + black, gray + black, or black + white.
---
Riser:
The best way to put it would be that if you would be comfortable using an HDPLEX, ADT, or some other riser with a 1050 TI, then you should be comfortable using a LiHeat riser as well. At the end of the day, un-powered risers are more similar to each other than they are different when it comes to power delivery. We recommend using them with lower wattage cards not because it is a sub-par product, but rather because it is a more conservative estimate of what kind of power it can handle in the long term.
