Retrofitting FormDT1 v2 AIO top hat for Jimu v1

[Truth]

Figured this picture would make following the changes easier, also thanks to Revenant for posting about it on the home page!
Measurements: 349.525 x 35 x 139.81mm
Support Improvement:
Alluminum: 45mm [27mm rad + 15mm & 1x 30mm on 120mm bracket]
V2 3d-Print: 60mm [27mm rad + 2x 30mm on 240mm bracket]

Files can be found here: [makerworld]
*One issue still exists, teeth need a slight inner bevel on the lip between the grills and the tooth, which was present on the white matte PLA as it deformed slightly, but the black matte printed them perfectly square.

Link to Revenant's article: [smallformfactor]

 

[Truth]

-[Moved to the above]-

 

[Revenant]

This is looking awesome!

 

[Truth]

File on makerworld has been added to the original post, practically everything is done. Once the final teeth modification is done, the project will only receive minor updates to the visuals of the listing on makerworld, and possibly the addition of a plate accessory for the sides for both aesthetics and ease of connecting the panels.