Retrofitting FormDT1 v2 AIO top hat for Jimu v1


Formerly TutorialIsland
Original poster
Mar 19, 2020

Figured this picture would make following the changes easier, also thanks to Revenant for posting about it on the home page!
Measurements: 349.525 x 35 x 139.81mm
Support Improvement:
: 45mm [27mm rad + 15mm & 1x 30mm on 120mm bracket]
V2 3d-Print: 60mm [27mm rad + 2x 30mm on 240mm bracket]

Files will be available when the project is complete, that way I can verify all fitment issues are resolved.

Link to Revenant's article: []
Last edited: