You do not need tabs my friend. The tabs are just nice to haves since you're already printing.
It might just be simpler to tighten the tolerance so it is wedged in there now that I think about it.
-
Save 15% on ALL SFF Network merch, until Dec 31st! Use code SFF2024 at checkout. Click here!
3D Printed Mod Corners - For 2D Panel Construction
- Thread starter Thehack
- Start date
You do not need tabs my friend. The tabs are just nice to haves since you're already printing.
It might just be simpler to tighten the tolerance so it is wedged in there now that I think about it.
No, interference fit means undersizing the hole so that the nut needs to be pressed in.
I think someone has before. I probably will use them for my 3D printed case parts too.
Similar threads
