Oh nice the socket's already available. Gonna look into the STP file later.
OH NICE THEY DO HAVE THE 2011-3 ILM BLUEPRINT, YAY
Little did I know
Passive Aggressive Haiku
Clever and I laughed
Last edited:
What did you do today?
- Thread starter craigbru
- Start date
OH NICE THEY DO HAVE THE 2011-3 ILM BLUEPRINT, YAY
Little did I know
Passive Aggressive Haiku
Clever and I laughed
Liquid snow~ (aka rain)
Interesting haiku
but last line "equals" not said
does that count or not
Interesting haiku
but last line "equals" not said
does that count or not
VegetableStu's right.
if a symbol is pronounced
you have to count it.
if a symbol is pronounced
you have to count it.
Updated the code in my tiny software renderer browser demo, new model and effect.
Replaced the demo model with a Roman bust that I downloaded from BlendSwap. I cleaned up in Blender and exported as a .OBJ with about 30K polys. I'd like to know what CPU and what framerates you're getting with the demo!
Replaced the demo model with a Roman bust that I downloaded from BlendSwap. I cleaned up in Blender and exported as a .OBJ with about 30K polys. I'd like to know what CPU and what framerates you're getting with the demo!
It works very well so far. Render times are 160 ms to 230 ms with SSAO off and 637 ms to 673 ms with SSAO on, on an i5-620M (a mobile i3 really).
Ah, not bad. I'm coding on my MacBook which has a slow-ish processor myself. Core 2 Duo 2.4 Ghz that gives me between 340ms and 450 ms with SSAO off, about 2000ms with it on. Looking forward to see how it runs on my home system with a i3 4130T.
It's currently limited to running on a single thread. I'd really like to apply web workers to make pixel rendering run in parallel. Its bottleneck is usually the fill rate.
Hovering around 250ms with SSAO on and around 58ms with SSAO off, using an i5 6600k @4,5gHz and because I'm lazy I'm watching a source quality twitch stream at the same time (1280x720@30p, 1660 Kbps)
Your spring must be defective, already had plenty of hours in the sun and a barbecue. #firstweekofsun2017
I'm just glad to see the sun more than 30 minutes a day during the work week.
Playing around with overclocks the past few hours. Can't seem to get my 6800K and NH-C14s under 46 degrees, so I'm still stuck at 3875Mhz @ 1.18125 which floats around 48 degrees at idle and 75 to 86 on full synthetic loads (currently only dealing with cinebench and small prime95 tests, not sure what others to try, and when should I pop the Aida64 trial)
And for laughs, I set it to run at 1500Mhz on 1 volt (with RAM still on 3000Mhz 1.3v. couldn't get cpu to run at 1200 because strap at 120). Took 30 seconds to boot, but kinda internet usable after getting into windows (cinebench clocked 486 on multicore, just under 491 on my old i7-870 setup, LOL. Didn't go above 50c though). I made this reply on chrome too (with my entire browsing session brought over)
And for laughs, I set it to run at 1500Mhz on 1 volt (with RAM still on 3000Mhz 1.3v. couldn't get cpu to run at 1200 because strap at 120). Took 30 seconds to boot, but kinda internet usable after getting into windows (cinebench clocked 486 on multicore, just under 491 on my old i7-870 setup, LOL. Didn't go above 50c though). I made this reply on chrome too (with my entire browsing session brought over)
Discovered that 80 grit sandpaper will make your fingers unrecognisable to capacitive fingerprint readers. It feels oddly rejecting to have your devices refuse to recognise you.
Similar threads
