Last edited:
J-HACK Mod Shop
- Thread starter Thehack
- Start date
-
- Tags
- 3d printed cryorig nh-l9i
120mm Adapter.
Hardware: i5-7400, Strix H270i
Tested using Prime95 + Unigine Valley looping. Measurements taken 3min after warm up, and AVG for 3 min runs. 50W package consumption with default fan control:
Using the NF-A12x15 + 8mm adapter, the cooler is much more quiet, since it is spinning at only 1275RPM AVG. You can use the RPM to deltaT for a good check of how effective each type of fan is.
Your set up may vary and I do not guarantee any performance uplift.
Hardware: i5-7400, Strix H270i
Tested using Prime95 + Unigine Valley looping. Measurements taken 3min after warm up, and AVG for 3 min runs. 50W package consumption with default fan control:
- NF-A12x15 | 68C | 1275RPM | Ratio of RPM to deltaT 30.4
- NF-A9x14 | 70C | 1790RPM | Ratio of RPM to deltaT 40.7
- Kazeflex PWM (120x25mm) | 74C | 1050RPM | Ratio of RPM to deltaT 21.9
Using the NF-A12x15 + 8mm adapter, the cooler is much more quiet, since it is spinning at only 1275RPM AVG. You can use the RPM to deltaT for a good check of how effective each type of fan is.
Your set up may vary and I do not guarantee any performance uplift.
Last edited:
New Product:
Adapter for LP53. Adds 2mm to the fan, but helps you keep your build clean.
Adapter for LP53. Adds 2mm to the fan, but helps you keep your build clean.
Last edited:
Nice! I have a T318 in the mail, consider me in
Working on a new product. T318 Fan Adapter.
It is on its way to USA. It'll be listed for $13 shipped and go on sale in about a week or so.
Fab.
Yuss. Is that Yate loon fan worth my money over a 2500rpm a9x14 or ty-100?
Similar threads
-
- Article