@Wahaha360 tested a ton of rads and that was the only one that fit
Check out the first post, it has all the information
Check out the first post, it has all the information
sorry if i missed something... didn't want to read through the 80 pages of forum. Is the problem just clearance for the height of the rad? In that case, I could just use a 12mm fan from scythe or something else that is thinner than 15mm, right?
^ Here is where I found a 12mm scythe fan if anyone is interested. under the specifications, you can see that it is 12mmScythe SY1212SL12L Case cooler - Newegg.com
Buy Scythe SY1212SL12L Case cooler with fast shipping and top-rated customer service. Once you know, you Newegg!www.newegg.com
For example the XSPC TX240 is 20.5mm thick, while the rad on the LT240 is 25mm thick. Even so, the TX240 does not fit because of the width. Since we don't have exact case measurements, we need to compare it to the LT240 which is 270 x 120 x 25 mm (LT240 fits with 25mm fan below PSU and 15mm fan below motherboard). So it may be possible to get away with a 27.5mm rad and 12mm fan depending on the other measurements.sorry if i missed something... didn't want to read through the 80 pages of forum. Is the problem just clearance for the height of the rad? In that case, I could just use a 12mm fan from scythe or something else that is thinner than 15mm, right?
For example the XSPC TX240 is 20.5mm thick, while the rad on the LT240 is 25mm thick. Even so, the TX240 does not fit because of the width. Since we don't have exact case measurements, we need to compare it to the LT240 which is 270 x 120 x 25 mm (LT240 fits with 25mm fan below PSU and 15mm fan below motherboard). So it may be possible to get away with a 27.5mm rad and 12mm fan depending on the other measurements.
I suspect length is not a problem. My biggest concern is if it’s wider than 120mm.I am really hoping I can get away with that, just ordered the water cooling parts and almost had an "oh sh*t" moment because I found out the rad was 27.5mm instead of 25.
sorry if i missed something... didn't want to read through the 80 pages of forum. Is the problem just clearance for the height of the rad? In that case, I could just use a 12mm fan from scythe or something else that is thinner than 15mm, right?
yes, with a normal slim fan, but with the one which I linked from earlier which is 3mm thinner than the normal 15mm slim fan, it should actually provide 0.5mm more clearance when using it with a 27.5mm radThe 240LT fits ONLY with the slim fan already, so no, nothing else is supported. If you look at the pictures, you'll see the one regular + one slim fan setup with the LT240 already.
@Wahaha360 Is there a new ETA on this? Purchasable this year? Oh and you dont happen to have any news on SFFLAB? Really looks great!
Ventilated aluminium and glass were going to be available for purchase sometime around d the release of the two toneLove this case, one probably dumb question however. On the off chance a future batch uses a ventilated, non-mesh panel -would you think they'd be modular additions to this first batch in place of the mesh?
Any updates on when the glass side panels will be released? Any small chance it will be sold with the first batch of black ones?