guys, ddc 310 from alphacool is full compatible
-
Save 15% on ALL SFF Network merch, until Dec 31st! Use code SFF2024 at checkout. Click here!
IceManCooler pump/res combo
- Thread starter rfarmer
- Start date
The 80mm fan mounting, that is on this res/pump, is no longer on the v6. You can still make it work if you really wanted to screw the res on the fan grates.
Been working with someone from IceManCooler to make an updated version for the v6's 92mm fan holes.
Very good. As long as thats not done, I can report the mounting adapter works pretty good. I did screw the Res at the bracket and then I used the cutting screws from the ncase to secure it to the case from the inside.
Very good. As long as thats not done, I can report the mounting adapter works pretty good. I did screw the Res at the bracket and then I used the cutting screws from the ncase to secure it to the case from the inside
I mounted it without problems, using the standoffs and screws of the pump/res to attach it onto the fan-adapter and then I mounted the whole construction with some standard fan-screws to the chassis from the inside.
Pics of the res are above, same for the adapter.
Did you end up using a 3D printed fan adapter or a commercially purchased one?
My concern is the weight of the fan adapter and distance would either cause the Iceman res to not sit flush or cause it to sag.
Prototype of the new version, en route for testing/validation.
If you're doing the testing/validation, is there any chance you could check for compatibility with SPC pumps? They should have the same mounting pattern as DDC, but perform better. If not, I'll get back to you guys with compatibility when the revised res hits the market!
I ordered an EK DDC 3.2 pump and heatsink to use with it. I like the SPC pumps with the single 4 pin PWM cable but opted to just go with what works.
Do you happen to know any mounts that you can buy online for the iceman? im about to grab a v6 once its available again and would really like to try and not have to jimmy rig the thing on. lol ill shoot you some cash if you could even send me one of the 3d printed ones if its working good for you! also since its not completely flush with the case does that mean you could mayyybe throw a fan in there too?
Where did you buy it ? Been googling all over the globe but cannot find that new v6 Iceman res... happy you test it and report though
It's not available yet but should be in the near future. Worked with the vendor to test and validate it with the V6 specifically.
Similar threads
