If we can, sure but not high priority.
There are 1000W and 1200W SFX coming, SFX-L won’t have these, so it’s not going to win in either power, efficiency or noise, so it’s basically an inferior choice in the long term.
-
Save 15% on ALL SFF Network merch, until Dec 31st! Use code SFF2024 at checkout. Click here!
Concept FormD T1 V2.0
- Thread starter Wahaha360
- Start date
If we can, sure but not high priority.
There are 1000W and 1200W SFX coming, SFX-L won’t have these, so it’s not going to win in either power, efficiency or noise, so it’s basically an inferior choice in the long term.
Who's doing these SFX monters can you share? Silverstone has only just introduced 1000W SFX-L in the virtual event last month
I'm struggling to find a use case for >1000W in SFF. Surely you'd run out of cooling before you hit the capacity of such a PSU?
The RTX 3080 is also rumored to have a new power connector that can support up to 600W. Maybe not needed for the 3080 itself, but future proofing for the next generation of GPU and the generation after that.
I’d buy either orientation.
I’m currently in a nouvolo steck (I couldn’t get hold of a ghost, the T1 wasn’t out, and I was moving a lot to cardboard box wasn’t an option ☹)
This offers everything I could want:
So excited for this case.
I’m currently in a nouvolo steck (I couldn’t get hold of a ghost, the T1 wasn’t out, and I was moving a lot to cardboard box wasn’t an option ☹)
This offers everything I could want:
- Better cooling
- Room for ssd’s (hopefully)
- Better quality (based on previous cases from W360)
- And, as someone who runs hackintosh almost exclusively, a slightly Apple feeling design.
So excited for this case.
Im on a 9700k but I swapped from clover to opencore, it was so nice to set up, and I think I would only have needed to change one kext if I’d been doing the same install on ryzen! Maybe not bombproof, but pretty close so far!
Hey @Wahaha360 i am planning to build a new pc. I am between buying an itx mobo or x570 asus impact which is a dtx mobo. Which is the posibility of P1 being compatible with dtx? x570 asus impact is a gorgeous mobo, will be also space for the dimm2 module? Thanks!
So out of curiosity I made some basic calculations (based off the T1) to see the minimum size the case will be to need to hold a 280mm 30mm thick rad +25mm fans. Then I did a seperate set to keep the proportions the same as the T1 assuming horizontal design. Hopefully I didn't screw anything up.
Minimum: 153x232x380 = 13.5 L
Keep proportions the same: 153x250x380 = 14.53L
Now obviously there will be more internal space which may be used for another rad or a pump res combo.
Minimum: 153x232x380 = 13.5 L
Keep proportions the same: 153x250x380 = 14.53L
Now obviously there will be more internal space which may be used for another rad or a pump res combo.
This would be my next build after T1! looking forward to the case
(I like the vertical one
)
(I like the vertical one
)
Last edited:
