Dr. Zaber Sentry AIO Cooled W/Full sized GPU

[Illoominatty]

Are my photos not showing up?

 

[rfarmer]

Are my photos not showing up?

I see them fine.

 

[Illoominatty]

Nice which AIO did you end up going with?

Corsair

 

[Illoominatty]

So I changed my vent setup for a cleaner look. I also got some parts in so I'm testing my G-unique out with my z370i Strix.

 

[Illoominatty]

Update: With the way I was able to route the tubes I was able to put a 25mm fan! Eventually I want to make a custom loop for thus but for now AIO will suffice. Now just waiting for my G-unique psu with custom length cable and c14 bracket.

 

[Runamok81]

That 25mm depth fan should make a difference. Very nice. Would something like this be possible for the GPU?

 

[NuclearLemons]

where do you plan on putting the reservoir for a custom loop?

 

[Biowarejak]

I imagine a t-line/drain-port would suffice in lieu of a res

 

[NuclearLemons]

I imagine a t-line/drain-port would suffice in lieu of a res

i also take it they'd have to use one of those pumps built into the water blocks?

 

[Biowarejak]

i also take it they'd have to use one of those pumps built into the water blocks?

Absolutely. One that's expandable

 

[NuclearLemons]

one of these?

 

[Biowarejak]

one of these?

Fractal Design's Kelvin unit might be better

 

[NuclearLemons]

Fractal Design's Kelvin unit might be better

likely a better one yeah

 

[Biowarejak]

Still, there does exist the pump used in the Kelvin unit, developed by Alphacool. That can be used by itself with a top in a very small volume.

 

[Illoominatty]

Kelvin would be the best option. The Alphacool AIO block/res is too tall. A T-line would be a good choice although the XSPC pump/res will fit in front of rad there is enough gap. Also could go with a shorter GPU for a bigger res option and pump.