Yeah, we’ll see. I only know of SilverStone’s upcoming 1000w SFX-L, but if there’s a 1000w SFX coming I’d happily take it.SEASONIC: NVIDIA GeForce RTX 30 Series Power connector
I feel like AMD should take the Efficiency Crown with the upcoming cards. Let's see.
-
Save 15% on ALL SFF Network merch, until Dec 31st! Use code SFF2024 at checkout. Click here!
Concept FormD T1 V2.0
- Thread starter Wahaha360
- Start date
Interested to see what the P1 and WinterOne do to factor in the odd/large designs of these new Ampere cards/coolers.
I think it's just the 3090 which is triple slot/XXX-thicc.... the old 3080 leaks were normal size.
And even so, I think the PCB will still potentially be easier to fit when paired with a waterblock.
And thirdly - the AIB cards are supposedly quite different to these more custom FE boards.
And even so, I think the PCB will still potentially be easier to fit when paired with a waterblock.
And thirdly - the AIB cards are supposedly quite different to these more custom FE boards.
Here's hoping you're right - since the double-sided fan design on the FE cards won't really work in most sandwich-style ITX cases.
Are you going to produce the Horizontal case ? I would buy one.
I saw that 8.5L was considered as an option. Does that mean that this case could be smaller than the T1 with improved radiator support?
With 280 rad support, this is not going to be 8.5L, should be about 14.5L...?
The below is from page 3 of the thread, before 280 rad was supported (because TRX40 mDTX, at some point)...
It has since been decided to go ahead with the Vertical version, with the added 280 rad support. Note the volumes listed above do NOT account for the additional space needed for a 280 rad...
The mainstream chassis mentioned above is coming it at 14.5L, see this thread...
Here’s hoping for more powerful SFX units to comfortably keep ahead of Ampere, after today’s confirmation of power usage...then again, you might not need it unless you run Intel
Looks like higher power SFX PSUs are in the works...?
Just a minor warning to those planning to go Founders Edition Ampere with the FormD P1 - Ali Sayed from Optimum Tech recommends against FE cards in sandwich-style cases since the fan exhaust on the backplate would get blocked by PSUs.
It will probably be a case by case (pun intended) in terms of how well the back exhaust hot air is able to be managed by each case (the blower style fan might be a boon in that sense since it'll exaust part of the air outside the case which may help for smaller volume cases with restricted airflow), but yes, sandwich style in general won't be ideal for this GPU. Looks like most 3rd party options so far however are going to be 2.5 slot so won't fit in the smaller sandwich cases.
Am I right in assuming that the P1and H280 are both waiting for renders to be greenlit before we can see them?
The rear fan on the GPU? Not sure how that would help, because at least in it's stock configuration it has access to cool air, reversing the fan would severely limit the cool air available to it by putting it right up against the PSU, so the thermals would probably be even worse.
I honestly don't understand why you would want to put a 3090 in a sff case, it's going to be kicking out an utterly ridiculous amount of heat. If a 3070 can trade blows with a 2080Ti, then a 3080 should be more than enough for 99% of people who aren't using their graphics card to make money.
Looking forward to seeing the final specs, release date and pre-order details for the H280 <3
Looking forward to seeing the final specs, release date and pre-order details for the H280 <3
