-Ok let's get started-
1. "The case"
I started the case design based on Thermaltake Core P1 (which is not sold in my country)
It is wood-based, thus, it marries well with Cassie (the plant)
Still missing some adjustments like, support for VGA and feet.
I started obviously with the Standoffs drilling, and the drawing of the cuts, where the cables would pass, Front I / O is from my old S340, from NZXT, I used a 3mm drill bit for all the holes.
2. "PSU and Drives"
The assembly of the SSD and the HDD were easy, a few screws are enough and ready, already the PSU,
I made holes for two screws, however, I found in my father's toolbox, a rail line, and folded it according to PSU , And I made a support assisting in cable mangement, in addition to the stand,
I put two iron plates, which served to hold the cables, and hold the WIFI / BT antenna
3. "MOBO"
Nothing complicated, just aligned everything, screwed everything, I connected everything, and I called, the only problem was with the BIOS (common in gigabyte, right?), I just loved the underglow audio light, even not liking LEDs in my hardware
4. "Config"
CPU: Intel Pentium G4560
MOBO: Gigabyte GA-H270N-WIFI
RAM: Corsair DDR4 2400mhz 8GiB LPX
PSU: EVGA 600B 600w Bronze Power Supply
SSD: Kingston UV 400 120GiB
HDD: Hitachi 1Tb SATA 2 7200RPM
THANKS FOR READ =D
1. "The case"
I started the case design based on Thermaltake Core P1 (which is not sold in my country)
It is wood-based, thus, it marries well with Cassie (the plant)
Still missing some adjustments like, support for VGA and feet.
I started obviously with the Standoffs drilling, and the drawing of the cuts, where the cables would pass, Front I / O is from my old S340, from NZXT, I used a 3mm drill bit for all the holes.
2. "PSU and Drives"
The assembly of the SSD and the HDD were easy, a few screws are enough and ready, already the PSU,
I made holes for two screws, however, I found in my father's toolbox, a rail line, and folded it according to PSU , And I made a support assisting in cable mangement, in addition to the stand,
I put two iron plates, which served to hold the cables, and hold the WIFI / BT antenna
3. "MOBO"
Nothing complicated, just aligned everything, screwed everything, I connected everything, and I called, the only problem was with the BIOS (common in gigabyte, right?), I just loved the underglow audio light, even not liking LEDs in my hardware
4. "Config"
CPU: Intel Pentium G4560
MOBO: Gigabyte GA-H270N-WIFI
RAM: Corsair DDR4 2400mhz 8GiB LPX
PSU: EVGA 600B 600w Bronze Power Supply
SSD: Kingston UV 400 120GiB
HDD: Hitachi 1Tb SATA 2 7200RPM
THANKS FOR READ =D
Last edited: