Batch #3 (5 cases sold out). Cases will ship before JULY-20. Blanks ordered at the factory.
Batch #2 (3 cases sold out). Cases will ship before JULY-8. Blanks are obtained. Assembly 2 days. Sending in painting.
Batch #2 (3 cases sold out). Cases will ship before JULY-8. Blanks are obtained. Assembly 2 days. Sending in painting.
Unfortunately no. The budget is very limited. Video card manufacturers refused to provide their solutions for the test.
Several photos of the stand for the vertical position of the case
Update revision 4.
Under the video card you can now install SSD / HDD: 2 x 2.5 "5-9mm
Another 2.5 "drive and 5-7mm thickness can be installed on top of the video card .If using a single-slot video card.
About other changes a bit later
Under the video card you can now install SSD / HDD: 2 x 2.5 "5-9mm
Another 2.5 "drive and 5-7mm thickness can be installed on top of the video card .If using a single-slot video card.
About other changes a bit later
What i think would be interesting is a case like the 3.6L one but with a sfx psu next to the gpu or mb whichever is easiest so it would be pretty long but short (would probably make the case taller to) To my knowledge there is no case like that out there.
@sergiiua
not sure if you have seen Guryhwas internal psu but it is considerably thinner than a flex atx. you could possibly fit it under the GPU. Even if you keep the same design as this but had the thinner psu you could fit a ton of drives above it. Also i think its passively cooled too so it would be MUCH quieter.
Might be woth contacting him about it, although it could be difficult as i think he is busy working on his own case design at the moment.
Guri has already sent me a PSU. I think the idea is good.
How about just big enough to fit a 1080Ti Mini?
i'm one of sergiiua's paying customers, Runamok81 is correct here.
i'm one of your paying customers, who is waiting for a Slim rev.4 case.
i agree with paullusty, i'm not interested in buying a case with a significantly greater depth [currently at 185mm] .
that design already exists with Dr Zaber's Sentry case.
the entire goal is to keep this case as small as possible.
however, i would pay for a case with a greater height.
paullusty's idea of putting an internal PSU under something else is very good, if you can keep your height below 69mm.
anything over 69mm or more in height will ruin the concept, which is a case that's as small as possible.
Last edited:
What about a even smaller Version for like LP 1050ti with external brick? it Would be around 3L. And since the 1050ti is able to handle most 1080p games and there is no alternative yet, I think it could be pretty nice.
