Case
- 325x153x300mm, 14.9L external volume (excluding feet)
- 325x153x320mm, 15.9L external volume (including feet)
- 14ga Al case, rubber feet, likely acrylic side panel
Motherboard
- mITX only
GPU
- 2.5 slot, 310mm max
CPU Coolers
- 55mm air cooler clearance
- Support for up to 2x240 rads (30mm thick w/ 25mm thick fans)
Storage
- 2x2.5" drives (max 14mm thick)
PSU
- SFX only (not SFX-L)
While I'm designing it with (limited) air cooler compatibility, it should be fairly obvious I'm designing this with the intent of doing a dual rad cooling setup. Most of the design choices were made with this in mind. Additionally, I'm going to be attempting to fabricate it myself, so made a couple of compromises to eliminate the need for welding as I'm...less than experienced in any kind of welding (eg, using standoffs/pop rivets in place of welding). I think I'll be able to get away with it since I do have access to a CNC router and a press brake?
I don't think I'd be attempting to sell this, as it's more of a personal passion project than anything? That being said, I'd love to hear anyone's thoughts on ways to simplify/improve on the design. Dummy checks are always appreciated ^^;;