Go with full length dual slot, avoid blower cards if you can!Will there be a significant advantage of going with mini-sized GPU's with the SM570 or would full length dual-slot cards do just fine? I reckon that mini-sized ones are more expensive than their full length counterparts.
Cerberus feet do work on these, might make the chrome feet an option on checkout later but for now you could snag them off the Cerberus page.
Appreciate the patience, glad Jack has you covered should get the coupon thing resolved tomorrow too!@KSliger no worries, I just got a nervous for a little while when you guys weren’t replying. If I was living in the US, I wouldn’t mind the delay but I have strict time constraints.
Jack reached out to me early in the morning though, so all is good. I just hope we can work out the quakecon coupon technicalities.
Right now we are shipping in 6 days or less for stock configurations.Hello, I don't know English, so some places don't understand. I ordered the SM580 yesterday. When do you usually ship it?
Is the bracket stuck in the top? Shoot us an email with pictures if something doesn't seem right, it might just be stuck.
Will post a picture of it tomorrow, shoot us an email if not. I have no pictures to post right now.
Did the other screws that looked the same thread in fine?There is SOME possibility that I used the wrong THREAD for the PCIE backplate, but that should just jam and not break. The driver fit fine. It didn't strip at the screwdriver - it just plain broke.
Also - welcome back!
I'll look into stainless if people keep having problems.
I have ordered the sm550 with slate gray panel option and i have already sent an email to orders contact.We can ship without switch, only takes $7 off though as they're a really cheap part of the case. Might be better to just take it to have while you get a replacement.
That is nice to hear! Thanks.Go with full length dual slot, avoid blower cards if you can!
Appreciate the patience, glad Jack has you covered should get the coupon thing resolved tomorrow too!
I'm afraid I threw away the broken screw before I inspected it. The screw currently holding in my GPU was from my big old box of extra screws but it threaded in fine so the issue wasn't the thread on the GPU backplate screw hole on the case.Did the other screws that looked the same thread in fine?
I know that KSliger suggested that you have the fans as exhaust but with my configuration I have found that setting both fans as intake work better for the 645. I've tested with vented panels as well as a windowed panel on the CPU side. With the fans as exhaust, I was seeing temps in the 70s on my 3700x. When I flipped the fans, my temps settle in at about 60 degrees while gaming. If there is a debate or this warrants more discussion, I'd be happy to run some benchmarks and report my results if it helps other people with their builds in the future.Nope, I have the fan on my 645 set to exhaust, like my case fan. When I had two case fans there was a significant difference in thermals between intake vs exhaust. I have both vented panels. Should it be intake?