PSU clearance for braided cables?

[batterybull]

Hey all, been lurking here a while and finally made an account! I'm currently planning out a scratch build with the new SF600 with braided cables and buying cable combs if they aren't included (come on Corsair!), but I'm unsure if I will be able to bend them to the backside of the panel as displayed below (front view). The panel is going to be 5mm acrylic and is currently sitting right above the psu with a 30mm tall opening. Any advice is appreciated!

 

[batterybull]

Here is a side view for clarification, with the left side being the back (where I'm trying to route the cables).

 

[NOKYARD]

I don't know if this will apply in your situation but i had to bend the 24 cables to make them fit my case's PSU frame. PCPartpicker didn't note the incompatibility until after i purchased the PSU.

I ended up bending the cables one at a time with a spudger (guitar pick works as well) being careful to not put pressure on the contact points by pushing the cables toward the plug while bending.

It's not ideal but it's worked fine for 4 years.

 

[NOKYARD]

Or something like this.

 

[batterybull]

didn't know those existed, thanks!