This is all progress in 1 post since starting it.
New project time, it's a MATX air cooled gaming rig, open chassis with carrying handle, really easy maintenance, hopefully I've put enough thought into it all holding together well.
Just getting the pieces made before I start bending/curving, assembling, doing a little each day on it.
Cut, drilled, tapped & added m3 brass inserts to the back IO expansion piece, made from 10mm acrylic.
Mounted to the back panel.
Mobo panel added.
Saving the curve cuts for when I have the curved pieces done to increase chance of lining up correctly.
Curved & bent the PSU cover, front panel is just resting in place.
Load of drilling & tapping for mounting the 33mm acrylic support blocks.
And added 10mm acrylic psu cover supports.
Fully mounted the psu cover supports & added the side panel.
New project time, it's a MATX air cooled gaming rig, open chassis with carrying handle, really easy maintenance, hopefully I've put enough thought into it all holding together well.
Just getting the pieces made before I start bending/curving, assembling, doing a little each day on it.
Cut, drilled, tapped & added m3 brass inserts to the back IO expansion piece, made from 10mm acrylic.
Mounted to the back panel.
Mobo panel added.
Saving the curve cuts for when I have the curved pieces done to increase chance of lining up correctly.
Curved & bent the PSU cover, front panel is just resting in place.
Load of drilling & tapping for mounting the 33mm acrylic support blocks.
And added 10mm acrylic psu cover supports.
Fully mounted the psu cover supports & added the side panel.