Hi,
I have just finished 3D printing the latest prototype of my 6.7 liter build. I decided to create my own case because I wanted to use a CPU fan that is higher than the ones supported by the DAN Case (my so far favorite sff case), while also not having to rely on a small form factor video card. In addition, I could not stand the idea of having wasted space in the form of slots for 2.5" or 3.5" SATA drives, as I am using M2 NVME SSDs .
I put the following hardware into the case:
I hope you like my design , you can print it yourself or customize it, it is available on Thingiverse.
I have just finished 3D printing the latest prototype of my 6.7 liter build. I decided to create my own case because I wanted to use a CPU fan that is higher than the ones supported by the DAN Case (my so far favorite sff case), while also not having to rely on a small form factor video card. In addition, I could not stand the idea of having wasted space in the form of slots for 2.5" or 3.5" SATA drives, as I am using M2 NVME SSDs .
I put the following hardware into the case:
- CPU: Intel i5-8600
- GPU: KFA2 GTX 1060 3GB
- RAM: Corsair Vengeance LPX 8GB 2666Mhz
- Mainboard: Asus ROG Strix B360-I
- 1st Drive: 500GB Samsung 960 Evo M.2 2280 NVMe
- 2nd Drive: ADATA 128 GB M.2 SSD
- Netzteil: SF450
I hope you like my design , you can print it yourself or customize it, it is available on Thingiverse.
Last edited: