Hi everyone, I am a PC enthusiasts from Taiwan.
This is my second time on an itx build, and my first time for a custom loop.
I spent almost a month to finish this build.
Here's my loop
Pump/reservoir -> CPU -> GPU -> 240 radiator -> 92mm radiator -> Pump/reservoir
For the pump/reservoir part, I've tried barrow's DDC and aquacomputer's D5.
Barrow's DDC is loud even in 3000 rpm, D5 is too big for an itx build. Finally I got a DDC310 from alphacool.It works well and quietly. With EK-XRES 100 DDC - Acetal, it's low enough to put it in the case.
For the GPU part, it's hard to found a waterblock for EVGA 1080ti sc2. I got one from bykski. However, it's a little bit big in ncase. So I got a L-shape block for it and use a thin radiator to fit them inside the case.
To have more cooling capacity, I bought a 92mm radiator and put it at the rear of the case.
For the custom cable, I got 40cm for CPU, 25cm for 24-pin, 18cm for GPU and 15+5 cm for SATA.
Since it's the first time for me to to the custom loop, I got a lot of fittings rather than bend the tubes.
Maybe I'll bend them more in the future. And I'll buy higher feet for the case.
This is my second time on an itx build, and my first time for a custom loop.
I spent almost a month to finish this build.
Here's my loop
Pump/reservoir -> CPU -> GPU -> 240 radiator -> 92mm radiator -> Pump/reservoir
For the pump/reservoir part, I've tried barrow's DDC and aquacomputer's D5.
Barrow's DDC is loud even in 3000 rpm, D5 is too big for an itx build. Finally I got a DDC310 from alphacool.It works well and quietly. With EK-XRES 100 DDC - Acetal, it's low enough to put it in the case.
For the GPU part, it's hard to found a waterblock for EVGA 1080ti sc2. I got one from bykski. However, it's a little bit big in ncase. So I got a L-shape block for it and use a thin radiator to fit them inside the case.
To have more cooling capacity, I bought a 92mm radiator and put it at the rear of the case.
For the custom cable, I got 40cm for CPU, 25cm for 24-pin, 18cm for GPU and 15+5 cm for SATA.
Since it's the first time for me to to the custom loop, I got a lot of fittings rather than bend the tubes.
Maybe I'll bend them more in the future. And I'll buy higher feet for the case.