Watercooling Ncase M1

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
Hi everyone, I am a PC enthusiasts from Taiwan.

This is my second time on an itx build, and my first time for a custom loop.

I spent almost a month to finish this build.

Here's my loop

Pump/reservoir -> CPU -> GPU -> 240 radiator -> 92mm radiator -> Pump/reservoir

For the pump/reservoir part, I've tried barrow's DDC and aquacomputer's D5.

Barrow's DDC is loud even in 3000 rpm, D5 is too big for an itx build. Finally I got a DDC310 from alphacool.It works well and quietly. With EK-XRES 100 DDC - Acetal, it's low enough to put it in the case.

For the GPU part, it's hard to found a waterblock for EVGA 1080ti sc2. I got one from bykski. However, it's a little bit big in ncase. So I got a L-shape block for it and use a thin radiator to fit them inside the case.


To have more cooling capacity, I bought a 92mm radiator and put it at the rear of the case.

For the custom cable, I got 40cm for CPU, 25cm for 24-pin, 18cm for GPU and 15+5 cm for SATA.

Since it's the first time for me to to the custom loop, I got a lot of fittings rather than bend the tubes.

Maybe I'll bend them more in the future. And I'll buy higher feet for the case.

 

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
I bought them separately. DDC310 from alphacool and EK-XRES 100 from EK.
 

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
CPU: AMD R7 2700X
MB : ASUS X470-I
GPU: EVGA 1080TI SC2
RAM: G.SKILL TridentZ RGB 3200 C14 8G*2
SSD: Samsung 970EVO 250G
MX-500 500G
HDD: HGST 2.5inch 1T
PSU: Corsair SF750

CPU : EK Supremacy EVO
GPU : Bykski N-TITAN-PAS-X
PUMP: Alphacool DDC310
EK-XRES 100 DDC - Acetal
Barrow FITTING
Barrow 1410 fitting
XSPC TX240
Alphacool XT45 92mm
Noctua A12X15
Noctua A9
 
  • Like
Reactions: Mrkhesin and Boil

RZEX

Caliper Novice
Original poster
Mar 30, 2019
29
48
The ambient temperature it around 30, and idle temp for CPU and GPU is about 40.
When I played PUBG, the temp would be about 70~75.
 
  • Like
Reactions: Boil