Trying to find a rather oddly shaped pump

[SeñorDonut]

So I'm designing a custom case and I realized I could make it really compact If I could find a pump that fits in a 16x60x80mm space. Does a pump like this exist? Right now the smallest I can find is 34x50x50mm.

 

[3lfk1ng]

Would a cpu block pump work with your application?

If not, would an Apogee XSPC mod work? (source)

 

[SeñorDonut]

Would a cpu block pump work with your application?

If not, would an Apogee XSPC mod work? (source)

Yes, looks like the Apogee Drive combo will just barely fit, assuming the inlet/outlets can be tilted to 90 degrees. Thanks!

 

[Biowarejak]

Have you found where to get one? Amazon was, for once, barren.

 

[SeñorDonut]

Have you found where to get one? Amazon was, for once, barren.

Swiftech or FrozenCPU

 

[Biowarejak]

Ah, but that's the later revision! Looks to be a bit larger

 

[Kmpkt]

http://www.frozencpu.com/products/1...Ceramic_12V_DC_Pump_w_RPM_-_Bulk_Version.html

This one is really small. You could make the tank around it custom I reckon.

 

[Biowarejak]

You could make the tank around it custom I reckon.

With 3D printing, proper finishing, and a thread tap, yes...

 

[Biowarejak]

This could work for you.... https://www.ekwb.com/shop/laing-ddc-pump-12v-ddc-1t-mcp-350

 

[CC Ricers]

Just another tip, you can replace the Apogee heatsink with something of a lower profile if you need extra room. The stock DDC pump bottom is very flat- It may just heat up a bit more since it doesn't dissipate heat as well.

 

[SeñorDonut]

This could work for you.... https://www.ekwb.com/shop/laing-ddc-pump-12v-ddc-1t-mcp-350

Thanks, but sorry that's way too thick

Just another tip, you can replace the Apogee heatsink with something of a lower profile if you need extra room. The stock DDC pump bottom is very flat- It may just heat up a bit more since it doesn't dissipate heat as well.

I was actually just going to keep it off