Concept TIPIO2 - dedicated GPU and internal PSU in <2.9L

[REVOCCASES]

somebody asked me if it would be possible to make a similar case like my TIPIO1 but with internal PSU and <3L volume...

Unfortunately I am currently busy with other stuff to turn that into an working build, but maybe I'll follow this up when I have some free time...

Possible specs:

• 250mm x 190mm x 55~60mm
• 2.65L ~ 2.85L
• Thin Mini ITX PIO Motherboard (e.g. JUBO H310C-G)
• Low Profile, Dual Slot GPU (currently up to GTX1650)
• HP 12VDC, 200W AIO internal PSU
• JONSBO HP400 (or similar) low profile cooler

Details / Layout:

Suitable PSU:

Suitable PIO Motherboard with internal 12VDC input:

Suitable GTX1650:

 

[robbee]

Looks awesome! Does the psu not block the mobo power input though?

 

[REVOCCASES]

Does the psu not block the mobo power input though?

You are right - that's why I haven't fixed the case volume yet - probably have to get a little bit creative there but it should work...

as a side note, my board came without that connector soldered on - so I would probably solder a 4P pigtail cable to the board to make the case as slim as possible

 

[milesvw]

I am running my H310 PIO off that header, as far as I can tell it wants 19v-20v. I say this because the port is directly connected to the rear power input, and the PCIe power is being reported around 10v. Which is in line with a minimum voltage drop through the DC-DC circuit there.
There may be some AIO PSU with 19v. Like LENOVO PA-1151-5 or Dell CPB09-007A