Concept TIPIO2 - dedicated GPU and internal PSU in <2.9L

REVOCCASES

Shrink Ray Wielder
Original poster
REVOCCASES
Silver Supporter
Apr 2, 2020
2,232
3,659
www.revoccases.com


somebody asked me if it would be possible to make a similar case like my TIPIO1 but with internal PSU and <3L volume...

Unfortunately I am currently busy with other stuff to turn that into an working build, but maybe I'll follow this up when I have some free time...

Possible specs:
  • 250mm x 190mm x 55~60mm
  • 2.65L ~ 2.85L
  • Thin Mini ITX PIO Motherboard (e.g. JUBO H310C-G)
  • Low Profile, Dual Slot GPU (currently up to GTX1650)
  • HP 12VDC, 200W AIO internal PSU
  • JONSBO HP400 (or similar) low profile cooler
Details / Layout:







Suitable PSU:



Suitable PIO Motherboard with internal 12VDC input:



Suitable GTX1650:

 
  • Like
Reactions: robbee and Goatee

REVOCCASES

Shrink Ray Wielder
Original poster
REVOCCASES
Silver Supporter
Apr 2, 2020
2,232
3,659
www.revoccases.com
Does the psu not block the mobo power input though?

You are right - that's why I haven't fixed the case volume yet - probably have to get a little bit creative there but it should work...

as a side note, my board came without that connector soldered on - so I would probably solder a 4P pigtail cable to the board to make the case as slim as possible

 
Last edited:

milesvw

Cable-Tie Ninja
Dec 20, 2022
151
105
I am running my H310 PIO off that header, as far as I can tell it wants 19v-20v. I say this because the port is directly connected to the rear power input, and the PCIe power is being reported around 10v. Which is in line with a minimum voltage drop through the DC-DC circuit there.
There may be some AIO PSU with 19v. Like LENOVO PA-1151-5 or Dell CPB09-007A
 
Last edited:
  • Like
Reactions: REVOCCASES