One of our community went and made this 3D printed tophat mod for sale:
https://www.etsy.com/listing/978598088/3d-printed-formd-t1-top-extension
Thoughts on the shorter tophat?
No excess flashing, parts were true and square. Follow the instructions. The fitment really hides the seam between the fore and aft pieces well.
Inside, a Corsair H100 Pro XT with 2x A12x25. NOTE, to get the mod on, the AIO needs slid aft towards the I/O backplane a bit. I far prefer the acoustics of the A12x25 to the x15, and there's ample clearance with this mod. The finish doesn't stick out too much from the aluminum, other than under lighting glare.
Worth the money.
https://www.etsy.com/listing/978598088/3d-printed-formd-t1-top-extension
Thoughts on the shorter tophat?
No excess flashing, parts were true and square. Follow the instructions. The fitment really hides the seam between the fore and aft pieces well.
Inside, a Corsair H100 Pro XT with 2x A12x25. NOTE, to get the mod on, the AIO needs slid aft towards the I/O backplane a bit. I far prefer the acoustics of the A12x25 to the x15, and there's ample clearance with this mod. The finish doesn't stick out too much from the aluminum, other than under lighting glare.
Worth the money.
