Low profile main power extension for Dan A4-H20

[GH247]

I am looking for a Low-profile main power cable that passes through power into the SFX power supply. Reason being is that I recently had to replace the EK 240mm AIO to a ThermalRight Frozen Prism and one of the tubes coming out of the radiator is being propped up by the C13 elbow connector.

Can anyone recommend any that are good? I can post some pictures later.

 

[NinoPecorino]

if you're not too concerned with the lack of strain relief overmolding and the extra jacketing you can get this: https://www.aliexpress.us/item/3256806188987354.html

 

[GH247]

Have you tried this? I did see this but was a little concerned about the exposed wires. I should be able to sort that out some

 

[NinoPecorino]

i used the same or similar cable in a t1 build and just wrapped the wires in electrical tape. sharp edges inside a case are really the danger for these cables. i wouldn't use it in a build i was doing for someone else but for a personal build i think it's fine.

 

[drew89]

Can anyone recommend any that are good? I can post some pictures later.

I have 2 tricks for you.
1. you can rotate the psu 180*, the connectors will be on the other side then.
2. you can ‘lower’ the psu by adding 4 (or 8 in total, 2 on each hole) motherboard standoffs. Link this: https://www.amazon.ca/Standoff-Motherboard-Standoffs-Spacers-Multiple/dp/B0FNC9Y8QM?th=1
You need to place them between the case psu bracket and the psu.
Pay attention at the thread pitch, try not to ruin the psu mounting holes. The screw 6-32 UNC.

Spoiler