Louqe Ghost S1 with hardline tubing

[b1ackwid0w]

I have two 2.5 inch SSD tuck behind PSU.


This is the first time I build my own custom sleeved cable and it took me 30+ hours.

The temperature is 85 full CPU load at 4.6GHz (8700k) add the titan xp can heat up CPU to 90 and the GPU max out at 82
I got those temperature after an hour of stress test and the fan has been set complete silent. around 700rpm

It barely fit in my pelican case

 

[rfarmer]

Looks great, glad to see you did a build log. I went the lazy way and got some @pslate custom cables, sure does make a difference. Can I ask which fans are you using?

 

[b1ackwid0w]

Looks great, glad to see you did a build log. I went the lazy way and got some @pslate custom cables, sure does make a difference. Can I ask which fans are you using?

silent wing 3 low rpm version

 

[cleveland]

This is the first time I build my own custom sleeved cable and it took me 30+ hours.

Watch out the housefire, dude...

 

[BaK]

Whatch out the housefire, dude...

This^
Thought the same when I saw your pic, you should have added some heatshrink tubings to isolate the naked wires:

 

[Coriolan]

Super job, case looks great inside and outside. Wiring though would make me a bit uneasy ;-)

 

[b1ackwid0w]

This^
Thought the same when I saw your pic, you should have added some heatshrink tubings to isolate the naked wires:

of course. the picture shown was just the test fit I sleeved all wires and heat shrinked the joint after the picture was taken.