Let me introduce you to Project 404 that Andy Lauder at Product Design Factory is building for me. He took a layout design I had and basic design and turned it into what you see below.
I wanted a tower case that supported a triple fan radiator. So that is what this design is based around.
It is 404mm x 130mm x 180mm. (H x W x D)
External panels are 2mm thick aluminum that will be black anodized and will have a Black Walnut Front inlay. The panels are held in place with magnets.
Its all pretty tight in there but it fits. Though I might make it 5 mm wider to just get a little bit more breathing room. Depends on a pump block that Andy is working with me on. Will show that design after we get it finalized.
Lehman
I wanted a tower case that supported a triple fan radiator. So that is what this design is based around.
It is 404mm x 130mm x 180mm. (H x W x D)
External panels are 2mm thick aluminum that will be black anodized and will have a Black Walnut Front inlay. The panels are held in place with magnets.
Its all pretty tight in there but it fits. Though I might make it 5 mm wider to just get a little bit more breathing room. Depends on a pump block that Andy is working with me on. Will show that design after we get it finalized.
Lehman
Last edited: