I've been working on a case for personal project of mine for a while and I'm about to get the parts cut soon, but I'm not sure about the dimensions for the rear I/O cutouts. Results from google and grabcad vary and I am afraid to get it wrong. I have been using mainly this image as reference.
How close should the motherboard be to the rear inside wall of the case? My current measurements seem okay but If anyone one has better/proven numbers that would be really helpfull. (Currently 2,2mm)
Then the I/O, this is were I am most uncertain. My case uses 12.5mm standoffs, My asumption was that the sketches I followed used 6mm as that's more common. Does it look alright?
I'm using 2mm thick aluminium panels bent with an inner radius of 2.6mm and am afraid the pci mounting screws will need a threaded hole in the bend (Like this) , in which case I'll have to drill those holes after bending.
some sources suggest that the 5,1mm measurement in this picture should be 8mm, yay or nay?
The whole case for those interested.
TLDR: More or less I am asking for accurate dimensions of rear I/O as those that I've found are so diffrent that I'm not sure which is correct. Or confirmation that my dimensions are correct.
Sorry if I posted this under the wrong category or part of the forums, I am quite new here.
How close should the motherboard be to the rear inside wall of the case? My current measurements seem okay but If anyone one has better/proven numbers that would be really helpfull. (Currently 2,2mm)
Then the I/O, this is were I am most uncertain. My case uses 12.5mm standoffs, My asumption was that the sketches I followed used 6mm as that's more common. Does it look alright?
I'm using 2mm thick aluminium panels bent with an inner radius of 2.6mm and am afraid the pci mounting screws will need a threaded hole in the bend (Like this) , in which case I'll have to drill those holes after bending.
The whole case for those interested.
TLDR: More or less I am asking for accurate dimensions of rear I/O as those that I've found are so diffrent that I'm not sure which is correct. Or confirmation that my dimensions are correct.
Sorry if I posted this under the wrong category or part of the forums, I am quite new here.