Resource icon

Cooling Corsair short straight Terminal Block for XG7 Waterblock 2021-05-01

No permission to download

Vaderator

Average Stuffer
Original poster
Bronze Supporter
Aug 7, 2017
67
155
Vaderator submitted a new resource:

Corsair short straight Terminal Block for XG7 Waterblock - Corsair GPU Waterblocks add significant width

The Corsair terminal design I used to create a straight low profile G1/4 terminal for my watercooled S4M.
I submitted it to be laser cut in 3 layers and then used JBWeld 4 to adhere the layers together.
The layer with the G1/4 terminal holes must also be tapped using a G1/4 tap (I used this one).

The G1/4 terminal layer should be 5.6mm and the other two can be thinner at 3mm.
I...

Read more about this resource...
 

stanleyguan

SFF Lingo Aficionado
Jun 18, 2020
114
321
Awesome job! Thank you so much for sharing! May I know what the specs are for the three screws? Looks like the middle one is a bit smaller than the outside ones.
 

Vaderator

Average Stuffer
Original poster
Bronze Supporter
Aug 7, 2017
67
155
Hi there - sorry for the delay. The screw in the middle is M3, and the outer two are M4.
I've been toying with a 3d printed version (using high temp resistant ASA filament) of this module that could be a lot more compact. I'll post once I'm done and have it working the way it needs to.