The ports are in G 1/8" instead of G 1/4" to reduce height. Total thickness to the back of PCB is 14.5mm (excluding terminal). Fits perfectly in FormD T1 v2.
Many thanks to @petricor on the original design I based this off of.
-
Save 15% on ALL SFF Network merch, until Dec 31st! Use code SFF2024 at checkout. Click here!
.STEP (Another) Minimized cover for Corsair Hydro X XG7 4090 FE waterblock 2023-09-01
- Author stanleyguan
- Creation date
The ports are in G 1/8" instead of G 1/4" to reduce height. Total thickness to the back of PCB is 14.5mm (excluding terminal). Fits perfectly in FormD T1 v2.
Many thanks to @petricor on the original design I based this off of.
More resources from stanleyguan
-
.STEP Custom reservoir for FormD T1 v2Fits at the rear of the case over the PSU female plug -
.STEP (Another) Custom PSU bracket for FormD T1Lowers PSU position by 4mm -
.STEP Custom straight-out terminal for Corsair XG7 waterblocksMakes Corsair waterblocks truly one-slot
-
.STEP Custom front and top panels for FormD T1 v2Ventilated front panel, and top panel with slots for greater ventilation than holes
-
.STEP Velocitop (DDC pump/block converter for EK Velocity CPU blocks)converts your existing EK Velocity block to include a DDC pump