Recent content by ScottSimply

From the SFF Gurus Discord:

From the SFF Gurus Discord: 160x256x366mm, 14.99L mITX and mATX, 135mm Air Cooler, Dual 280 Radiator / AIO Afaik, supports all 4090 GPUs either via direct insert or via PCIe Riser, except the following: - XLR8 Gaming UPRISING EPIC-X RGB Triple Fan (365mm length is too long) - Apocalypse OC (天启...

All major updates are posted here as well, no worries. M1 Evo and O1 mATX are both mATX, M1 Evo and O1 mATX are basically the same case, just with a different front panel.

It is also about the T1 v2, the gen 4 riser should restock at some point soon. But you can also get the same one FormD uses for the T1 v2 SW from i.e. aliexpress: https://aliexpress.com/item/1005004123118421.html, you'd want the 18.5 cm one. The louqe cobalt riser also works...

From W360 on the SFF Gurus Discord:

V1300 results haven't been published yet, but the v1100 is a little louder than the 850r extreme sfx up until ~700W, but yeah not by much. There is also a big price difference though. For the vast majority of people SF750 is still the king, it can run a 4090 + 13900k just fine, and it is...

The Silverstone 850R Extreme SFX is significantly quieter than the CM SFX units. You can find detailed noise charts (and way more) on Cybenetics' site: https://www.cybenetics.com/index.php?option=power-supplies.

Yes. There will be an mATX model (basically same as M1 Evo with a different front panel), and an E-ATX model of which the details are still very sparse, but SSI-EEB mobo support and <19L was said so far.

Wanted to share this here as well:

There's quite a few like-minded people on the SFF Gurus Discord, quite a few dual rad T1 builds there too, a lot of them even using 6/8mm tubing and pneumatic fittings, can join it at: https://discord.gg/sffgurus The tubing above the PSU going into the rad looks a bit pinched, I'd be worried...

For most users the ATX 3.0 specs are absolute overkill, and they would prefer a 600W 12vhpwr connector on a 850W PSU. However that does mean the PSU does not meet the full ATX 3.0 specs, and that's a loss marketing might not appreciate. Personally I prefer not having 12vhpwr on the PSU side at...

The v1.1 can fit a 4090 FE, the 1.0 is very rare but is the same as the v1.1 GPU support wise. I do expect the 4090 to do a little better in the v2 compared to the v1.1, but should still be totally fine.

Not yet

The CM 1100/1300W is already available in the Asian market, a few Hong Kong stores stock it. Cybenetics has one coming so hopefully we'll get a proper analysis soon, I'm expecting it to be very loud.

Whilst the cable and specs do say it is rated for 450W, supposedly on the units delivered so far the sense pin configuration is actually set up as 600W connector. This is potentially a sourcing issue, and might be "fixed" at some point down the line. Hopefully it'll be a little clearer once more...