Recent content by PseudoPsyche

  1. P

    Production NCASE M1EVO

    I'd also like to know both answers, as well as if this can comfortably fit an SFX-L PSU with a 4080 FE installed?
  2. P

    Production NCASE M1EVO

    Amazing, thank you! So it could theoretically fit a 145mm height air cooler if not using a 4 slot GPU? (I just saw that the site lists 135mm max height if using 4 slot GPU, so just want to double check as I didn’t see this info before)
  3. P

    Production NCASE M1EVO

    Sorry this has been covered somewhere, but it wasn’t 100% clear to me. Will this comfortably fit a top (or bottom if needed) mounted GPU (7900XT) + SFX-L PSU + 240-280mm radiator (or 145mm height air cooler)?
  4. P

    DAN A4-SFX v4.1

    Any update on this? I'm thinking of ordering the LINKUP riser, but won't if this may still cause issues.
  5. P

    DAN A4-SFX v4.1

    Has anyone had an issue with excessive noise from the fan mounted to the bottom of the case below the motherboard? I’ve finally started getting my build up and running, and have noticed this fan (a Noctua) is very high pitched and much louder at idle (~1200 RPM) than even my GPU fan under...
  6. P

    DAN A4-SFX v4.1

    Here’s a pic of what mine looks like routed over (I’m also using the shorter PSU bracket made by LoserCard): And this is the amount of bulge it results in:
  7. P

    DAN A4-SFX v4.1

    I have an Asetek 645LT with Trident Z Neo, and the tubes fit over top with a slight bulge in the side panel when closed.
  8. P

    DAN A4-SFX v4.1

    They should all be M3 screws, which you can usually find at most hardware stores (if in the US, I can confirm Home Depot does). Not sure of the length, but I’d just take one of the other screws with you to compare at the store.
  9. P

    DAN A4-SFX v4.1

    Awesome, great to hear! I don’t mind the bulge too much, just wanted some confirmation on whether this was realistic since it’s what I was hoping to do in my upcoming build. As far as the specific memory, the Trident Z Neo look super similar to the Trident Z RGB, so it doesn’t seem like there...
  10. P

    DAN A4-SFX v4.1

    Can anyone with an Asetek 645LT comment on if it’s possible to route the tubing around non low profile memory, such as the GSkill Trident Z Neo?
  11. P

    DAN A4-SFX v4.1

    It’s in stock at Overclockers UK: https://www.overclockers.co.uk/dan-cases-a4-sfx-v4-mini-itx-gaming-case-black-ca-006-da.html Just got mine from there recently.
  12. P

    DAN A4-SFX v4.1

    Could we just swap out the riser on the v4 case ourselves if there is a need for PCIe 4.0 in the future?