Recent content by Daemos

  1. D

    Production FormD-T1 (aka Sidearmd), READ FIRST POST

    I really hope this preorder drama is solved in September with a larger batch.
  2. D

    Production FormD-T1 (aka Sidearmd), READ FIRST POST

    Well first time i've tried to do it...wish I slept instead haha.
  3. D

    Production FormD-T1 (aka Sidearmd), READ FIRST POST

    It looks like Canadians have good taste in cases!
  4. D

    Production FormD-T1 (aka Sidearmd), READ FIRST POST

    Yep...cept I'm a 🇨🇦 in 🇦🇺
  5. D

    Prototype [Updated] LytCase Rogue: 8.6L Sandwich style case with 240mm AIO support.

    That's the other concern...even if you can air cool the CPU...the next gen GPUs may need 3 slots to be cooled adequately
  6. D

    Prototype FreeFlo 48mm CPU Block + Pump

    It would be good to use in many sff cases!
  7. D

    Prototype [Updated] LytCase Rogue: 8.6L Sandwich style case with 240mm AIO support.

    Yeah I think it would be pretty awesome to get a small compact case that can do a 280mm radiator. But it seems difficult.
  8. D

    Prototype FormD-P1 (Sidearmd) 280/240AIO Support Case

    So out of curiosity I made some basic calculations (based off the T1) to see the minimum size the case will be to need to hold a 280mm 30mm thick rad +25mm fans. Then I did a seperate set to keep the proportions the same as the T1 assuming horizontal design. Hopefully I didn't screw anything up...
  9. D

    Prototype [Updated] LytCase Rogue: 8.6L Sandwich style case with 240mm AIO support.

    I was going to suggest adding support for a 280mm AIO... But realised it would need 25mm thick fans and the change would make the case at least 11.8L just to accommodate a 280mm rad plus 25mm fans! Huge difference in size!
  10. D

    Concept IN 0 - An extreme pure vertical ITX case (In production)

    I think being taller is better as well...for the 280mm rad support how thick is supported and with what type of fans? Is there enough space to install a waterblock on the GPU?
  11. D

    Prototype FormD-P1 (Sidearmd) 280/240AIO Support Case

    I really do hope this case can really support a 280mmx30mm radiator with two 140mmx25mm fans...it will be amazing.
  12. D

    Prototype [Updated] LytCase Rogue: 8.6L Sandwich style case with 240mm AIO support.

    This is a very interesting case, will there be enough space to have water cooling fittings for the GPU?
  13. D

    Production FormD-T1 (aka Sidearmd), READ FIRST POST

    No you are right. I read it wrong it's only the multi-gpu blocks that are incompatible...my fault for reading it when I'm half asleep!
  14. D

    Production FormD-T1 (aka Sidearmd), READ FIRST POST

    Unfortunately I don't think I meet the cutoff if it's based on the date you first posted in this thread...however, I have been following the project for quite some time and have had an account for three years before the Optimum Tech Video.