Latest activity
-
K888D replied to the thread Production Lazer3D HT5 - Low Profile APU Case.I can see how this could be an issue yes, the back panel is 5mm thick so you need a thread of at least 7mm. You can usually buy... -
K888D replied to the thread Prototyping Lazer3D - LZ XTD - Alternative Designs.I look forward to seeing that when its complete!
-
K888D reacted to Reldey's post in the thread Prototyping Lazer3D - LZ XTD - Alternative Designs with
Like.
In anticipation, ripped out my system out of the Dan Case, and got the NH U9S. Putting it in a Thermaltake Core V1 for now, anxiously... -
K888D replied to the thread Production Lazer3D HT5 - Low Profile APU Case.You were bob on with your first guess, they are for ITX boards that don't have built in antennas onto the rear IO.
-
K888D reacted to steelfractal's post in the thread Production Lazer3D HT5 - Low Profile APU Case with Like.
forgot about the L9x65 here is what it looks like so far are getting custom side panels made as the standoffs don't line up with the...
-
K888D replied to the thread Production Lazer3D HT5 - Low Profile APU Case.Most of my heatsink comparison testing was done in the LZ7 and the L12S has been the top performer I've tested so far for sub 70mm...
-
K888D replied to the thread Production Lazer3D HT5 - Low Profile APU Case.Ideally you want at least 10mm between the top panel vents and the fan for minimal air turbulence noise. This is one of the benefits of...
-
K888D reacted to Valantar's post in the thread Production Lazer3D HT5 - Low Profile APU Case with Like.
AFAIK you would struggle to fit the UHP-200-12 in the HT5. I asked @K888D about the same a while back, and while there is a theoretical...
-
K888D reacted to Valantar's post in the thread Production Lazer3D HT5 - Low Profile APU Case with Like.
An SFX PSU is about half the total volume of this case (well, that might be a small exaggeration), so that would probably require a...
-
K888D replied to the thread Production Lazer3D HT5 - Low Profile APU Case.You may already have done this but you can usually download some control software from your motherboard manufacturer's website, once...
-
K888D reacted to smitty2k1's post in the thread Production Lazer3D HT5 - Low Profile APU Case with Like.
In addition to what others said about idling in windows instead of the BIOS, did you check your CPU fan curve? The ASRock B450 itx has a...
-
K888D reacted to TheHig's post in the thread Production Lazer3D HT5 - Low Profile APU Case with Like.
All of my Ryzen systems idle at higher voltage and clocks in bios — meaning higher temps. Recommend getting your OS going and evaluating...
-
K888D replied to the thread Production Lazer3D HT5 - Low Profile APU Case.Hey, those temps seem absolutely fine to me for the BIOS, anyone else have an opinion on this? Usually leaving your PC in the BIOS...
-
K888D replied to the thread Production Lazer3D LZ7 - Quiet Gaming Cube PC Case.I've seen a few people do it, this guy did it to match his Spiderman themed build: https://pcpartpicker.com/b/wbQZxr
-
K888D replied to the thread Prototyping Lazer3D - LZ XTD - Alternative Designs.Welcome to the forum and thank you for the kind comments. Regarding wood panels for the top and sides - there aren't currently any...