Normal
Bad news... print failed at about 42 hours in. Son of a... It looks like there was some droop in the wire whip going to the effector assembly that only revealed itself with a taller print. It looks like the whip gat caught between the part and the moving head and knocked things out of alignment. I've fixed it now so it won't be an issue in the future. However, i've lost irreplaceble time. It's now printing again, but I'm not sure there's enough time to fully complete the case by the 6th of October. My goal at this point is just to get the bare minimum done in order to get the components inside. We'll see how that goes.On the bright side, since I was unhappy and needed some kind of gratification, I bought an Asus PG348Q, lol.
Bad news... print failed at about 42 hours in. Son of a... It looks like there was some droop in the wire whip going to the effector assembly that only revealed itself with a taller print. It looks like the whip gat caught between the part and the moving head and knocked things out of alignment. I've fixed it now so it won't be an issue in the future. However, i've lost irreplaceble time. It's now printing again, but I'm not sure there's enough time to fully complete the case by the 6th of October. My goal at this point is just to get the bare minimum done in order to get the components inside. We'll see how that goes.
On the bright side, since I was unhappy and needed some kind of gratification, I bought an Asus PG348Q, lol.
