lowest profile cpu block with right angle fittings for am4

[Elerek]

Having some trouble finding the heights for cpu blocks and fittings.

Best I can tell:
keep out zone under a motherboard is 4.1mm
motherboard thicknss is ~1.57mm
am4 socket height 7.35mm (source https://hardforum.com/threads/am4-socket-dimensions-help-needed.1930302/)

I'm trying to make a custom case with an interior height of 50mm, so that only leaves ~36mm or clearance for a cpu block and some right angle fittings.

Anyone know of a set that would fit?

 

[Kmpkt]

https://www.ekwb.com/shop/ek-annihilator

You can swap the barbed fittings out for barbless in a normal hard/soft tube size and go from there.

 

[Elerek]

https://www.ekwb.com/shop/ek-annihilator

You can swap the barbed fittings out for barbless in a normal hard/soft tube size and go from there.

That's for 2011 and 2011-3, not am4

 

[GentlemanShark]

This guy is a really low profile water-block and supports AM3, so depending on your mobo, it may be compatible. Similarly, you could make a bracket if it doesn't work.

 

[Kmpkt]

My bad.