Recent content by Temo

Hello Valantar There are room for routing the PSU cable to the back, se my post #10. Yes a mesh would be better. Carbon fiber was chosen do to that I wanted a stiff and light plate, that wouldn't short the GPU, as it very close to the plate, but I guess the riser cable between the GPU and the...

Not much more to do, keep it simple.

Yes it would, and I'm been a bit wasteful with the space in the GPU area, one could do something with the space under the GPU. I was thinking it was a good area to stow away the extra length of the cables.

Thank you. So the skeleton is done, 2 mm carbon fiber plate with bracket for PSU, GPU and PCI-e riser cable.

So just a quick update exterior vise. All air to CPU, PSU and GPU are taken directly from the room, and heat from CPU and PSU are separated from the GPU. Need to make some vents in the bottom and top, maybe also a small 40 mm fan in each end of the GPU department. As for the IO plate, I was...

Thanks guys, will look into Imgur!

Hello Early concept stadium. Case 290 x 180 x 130 mm, one groove/track to "slot" in your ready made build. Any service/fault on your parts, just pull the card, fiks the problem and slot back in. https://photos.app.******/TDfTTPqmax3CrQDt7 https://photos.app.******/YKG45nzCKhVQphGJ8...

Hello Anyone tried running a 1 slot Inno3d-gtx-1050-1050-ti in the A4-SFX case? https://www.tomshardware.com/news/inno3d-gtx-1050-1050-ti,34480.html It could maybe be run with the Noctua NH-L9x65 to get better cooling to a i7 8700 non k if one move the dividing wall over one slot? Terje

Hello So I'm putting together a A4-sfx v3. It will mainly be used as an desktop PC, with light cad work and no gaming. My hope is to get a as silent PC as possible on my desk, so it need to run cold as well. - Asus z370i - i7 8700 non k(delid + under-volt) - Corsair SF450(or do I need the SF...

Thanks

Hello Tsuchinoko! Thank you, that was my concern. Are you using the drive for your OS, and how many other drives have you installed? I think I will go for three drives then: - one 970 Evo NVMe 250GB for my OS and programs - one 860 Evo SATA ssd 250GB for my project files - one 860 Evo SATA ssd...

Hello I see a lot of builds with Dan A4-sfx and Asus z370-i, but cant seem to figure out if you are using two NVMe SSD drives in the case. My questions are: - will you get full bandwidth with two NVMe SSD drives and two SATA SSD drives(four drives all together)? - will it matter witch drive the...

Hello Thanks for a good forum! I'm drawing up a 3d rep. of a ASUS ROG STRIX Z370-I Gaming, S1151 motherboard to see what room I got for my parts, but I seem to have a problem, I think. Isn't the CPU exactly centered in both direction in relation to the four mounting holes for the CPU cooler...