Recent content by seba

I checked my cable again. I would not say it was necessary. I was able to get the panel closed with the cable on top of the heatsink or under the fan. It works either way, but I think I feel a little less pressure on the top panel when the cable is under the fan. The motherboard I am using is...

Sorry for the late reply. Yes, there is enough clearance under the gpu to put the 15mm fan.

Sorry for the bad image. I think I ran into the same issue as you did. You can unscrew the plate and the power cable and reroute it and switch sides. In this case the cable still hits the fan so I slid the fan to the front a little bit and put on the clips in the shifted position. The small...

I only had 5 too. I thought I lost it some how it or it was only me missing. I used the m3 pan head w shoulder for the gpu bracket. It sticks out but it worked.

Hi guys. I was able to fit the SAPPHIRE PULSE RX 5700 in M1 V6. The side panel do close. FYI, the motherboard is MSI B450I GAMING PLUS AC and PSU is Corsair SF600 Platinum. But yes, installation was difficult. For me, the back was not so much a problem thanks to the flexible cables. I was able...

I thought sff lab sold the power cable with the different angle, but cannot find it now. Is it going to be restocked? I want to use it since I am mounting the psu in the front with the fan facing the motherboard.

OK. Thank you for your advice.

Which way should I mount the PSU in the ATX position when using the C14S with a 140mm fan? The fan facing front or back(fan facing motherboard side) ? Or will it be better for the PSU to mount it in SFX position with the 120mm and the PSU fan facing outside (fan facing vented holes) ?

Thank you. That will be very helpful.

@Necere Hi. Just ordered my M1 and joined. My question is Do you have the exact dimension of the panel and where the M4 holes should be on the panel? I wanted to get the TG version and try the NH-C14S setup. But since it is not ready yet, I was thinking of getting a custom order panel at a...