Recent content by PunchingBagz

Sorry for the delay. Thanks for suggesting the vid. The "buttons" are actually touch-sensor based, not physical. Hence why just wiring them directly wasn't an option. If I were modding an Xbone S, that would've been a different story. I also went and skimmed through Ben's mod videos with the...

Does anyone here have any experience modding the Xbox One? I'm in the finishing stages of building a PC in my old enclosure, but I've been unable to find much online on how to mess with the RF board. I have kept tabs on similar mods with the 360, though I'm unsure how similar the two consoles...

Mind showing me a picture or at least a sketch of what the duct looks like in your case? I'm guessing this works like a blower style cooler for a GPU (?)

Yes, in fact that was what gave me the idea to do this to my Xbone instead of scrapping it :p Main problems I had with trying to use that build for help were: OP built it in an Xbone S rather than an original Xbone. Differences vary from minor (easier to pry open, noticeably smaller) to rather...

Care to go further into detail? I'm honestly new to builds that require actual modding. That and I don't want to make any drastic changes to the top panel beyond drilling a few holes if needed (console is special edition so I would prefer to preserve that look as much as I can :))

Hey all, currently planning to build an HTPC in my retired Xbox One. Thing is, what I noticed is that while the top panel has a vent for airflow, it's located towards the front half of the chassis and only appears small enough in diameter for the 112mm cooler that came with the Xbone. Assuming...