Recent content by LoserCard

(Posted twice)

You can use coarse thread M3.5 screws but keep in mind that you will be cross threading (42 TPI vs 32 TPI) in the radiator. The most important screws are for fastening the radiator which is what uses 6-32 1-1/4” and 1-3/8” screws. The 1/4” screws can be replaced with M3 or M3.5 since these are...

Bad news... Only the Lian-Li adapter would work because the USB header keyslot is facing towards the PSU on all of the adapters you linked. This means that the USB 3.1 header would be probably touching the PSU with no additional room to spare. The Lian-Li one has the keyhole on the opposite side...

Just received some A-DATA 8GB x 2 VLP sticks from Aliexpress. Current OC is 3600MHz 20-21-21-40 1.35v. Unfortunately I am not able to tighten the latency on any frequency. It always sticks around the same ratio (3466/CL19, 3333/CL18, 3000/CL16). I stuck with the highest frequency due to the best...

@bobokun Yes, most SFX PSUs have a loud relay click. I haven't really noticed this with larger PSUs but have with all of my SFX PSUs (Corsair and Silverstone).

@againstodds I run a 9700k with a 645LT custom setup which allows me to use a 92x25mm fan and cool up to a 150-160W package. I am able to run my system at 5.0GHz 1.360v (-0.030 offset) in Realbench at 80C and Prime95 (non-AVX) at 85C (>30 minutes) or AVX loads with AVX offset -2. A 9900k runs...

Thanks for the mention. To the OP, here is the bracket I sell (note, this is an old picture/version of the bracket): They move the PSU up about 6MM upwards which helps a ton especially if you are using stock cables. I sell these for $20 shipped to the US and around $30 shipped...

For anyone interested in overclocking (yeah you read that right) an i7/i9 in a Dan A4 (v4) you might want to check out my kit: I am currently running an i7-9700k 5.0GHz all core @ 1.360v stable ~80C (stock STIM) in Realbench Stress Test loads and ~85C in Prime95 (non-AVX). STL files are...

I am selling both a full kit (including full wiring kit, custom brackets, fan and hardware) as well as the PSU bracket by itself. Here is my post in the forum. Also I have posted this kit on Reddit r/sffpc: HERE If you own a 3D printer, I posted the STLs here (non-brass threaded insert...

Hey guys, Just thought I would chime in and join the Dan A4 club. I mostly post on the subreddit r/sffpc. I did a highly customized cooling solution with the Asetek 645LT. Here's my build:

ALL PREORDER SLOTS CURRENTLY FULL! Preorders will resume once all current orders have been fulfilled. Hi All, Prefix: I'm new here and I mostly post in the subreddit r/sffpc. I wanted to share my build on this forum because I feel that anyone that wants uncompromised performance from the Dan...

@dondan At first I thought the USB-C port on front was a poor decision due to the lack of adoption on peripherals (aside from phones) at this point in time (don't get my wrong, I think your case is the best utilization of space for components of any similar designed cases), however, I found the...