Recent content by jakkuftw

160 Eur.

It's for corsair sf600

180 Eur if anyone is interested.

Hello everyone, I'm upgrading my sffpc setup to nr200p while waiting for new C4. Without any scratches outside, good quality DAN A4 SFX v4 + pre-installed Asetek 645LT AM4 with Noctua NF-A9x14 PWM + custom cables for Asus strix x570-i. Looking for 160 Eur + shipping to EU. Case with all addons...

Nice! From aesthetics point of view is it possible where is power button and usb c to make it flat without top hat cutout?

Is it possible to align case vent holes? I mean top hat and side panels ;)

Is it possible to align case vent holes? I mean top hat and side panels ;)

Thank you! Can you post a pic or send to pm?

Anyone can confirm that asetek 645LT tubes can get over gskill trident z and close the case nicely? I heard some talks it works.

Can someone measure lenght pslatecustoms unsleeved 24pin atx cable and cpu/eps?

I think you do something wrong, when I first time installed gigabyte 1060 g1 gaming, I had something like this, but check everything closely it should fit.

I do not recommend use any of 2,5" ssd. Because you need to connect sata power cable to psu, because of that one of the AIO pipe will be little bend on the side... Today I had worked on that for about 3 hours to fit SF600 Platinum cables..

Is it necessary plastic shield in DAN A4? Because with Asetek 645LT it's impossible to use with psu cables.

You don't need memory faster than 3200 CL15-14..

Is it possible to use 105w tdp cpu in DAN?