Recent content by Hanakuso

Just have patience everyone. I still remember I missed out on the first run of the M1 and it wasn't 100% another run would happen. Ebay prices were crazy high.

Tempting but i'll probably wait till they go on sale.

Does anyone know of a place that has 4.0 risers we can upgrade to? I'm planning on using this case for years and by then 3.0 will probably be slow.

As far as I know, there's no such thing as V1 or V2. It's all the same name, just defective or post-defective batches.

Is low profile RAM required if we go with a slim 120mm fan for the black ridge?

It would be nice if V4 owners could buy the 3M cable separately if it becomes available.

I got those 3mm spacers made for the feet. I have not done any test but I did notice slightly less noise from the fan. Might just be a placebo. IMO the case looks better with the stands. I think the case looks like it’s missing feet’s without them

Does anyone else have this issue? It looks like the top and side panels don't sit flush. It's mostly noticeable on the top here. Any solutions?

Has anyone went from an air cooler to AIO cooler and notice any temp changes other then the CPU? I have 2 case fans and 1 CPU fans with my air cooler. I feel like going with the 645LT would obviously bring my CPU temps down but with only 1 case fan bringing in fresh air things might get hot

It's touching the "separator" but I don't know how much heat can transfer by just touching. I have some extra thermal tape I could try later. I was afraid to do this since I would expect the GPU to heat it up. Btw, I got a fan duct printed up and I realized I didn't even need the high profile...

I never reinstalled the original Samsung copper heatsink/label. I'm guessing that made it perform worse. But yeah i'm still suprised by the temp drop since the temps in the Dan A4 is worse compared to my old M1 case. Then again maybe the bottom fan is helping to move around air behind the mobo.

I ended up buying a cheap heatsink and it reduced the temps dramatically. Around 20-25C in gaming for both temp sensors on the SSD. Here's what I bought. https://www.amazon.com/gp/product/B074Y5DZ4N/ It's about 1mm to thick so it does push on the motherboard stand slightly.

Does anyone know if the countersunk screws for the case panels are typical or unique to Lian Li? It would be nice to buy screws that color match the case closer. IIRC, the NCase M1 countersunk screws have a slightly different angle compared to standard M3 screws

I'm noticing my 970 Evo hits the mid 70s with a fan below it. The SSD is behind the mobo. I don't have the stock copper heatsink (Label) since I had an EK heatsink on it but I just ordered a slim heatsink. I'm hoping it fits and reduces the temps.

I believe they stopped production about a decade ago. I picked up 2 dozen on clearance for $6-7 each. I think i'm down to only a handful now.