Its not as quite as a D5 that's for sure, which I knew moving to a DDC unit, but without having the prior experience to rely on its difficult to gauge.
It does come with vibration pads for the screws but I didn't install them and I haven't heard any vibration noise using the EK 3.2 DDC PWM.
Checked back through the last several pages I'd missed to see if anyone had tried it yet. I found some time and installed the Iceman NCASE M1 DDC Pump/Res unit to the back of the mATX Cerberus. Very pleased with the result.
The other day I was putting in some time into the concept of 2x240mmi in the mATX Cerberus. With the mATX motherboard installed, I was able to fit a FlexATX PSU in the sideways position where the front mounted SFX PSU goes. I still need to design and print a mount for the FlexATX PSU to...
I have my PSU front mounted with two SSDs installed in their slots so I ran the SATA cables and power cables up the side of the motherboard and behind the PSU.
I then ran my 8pin over the top of them and flat in between the motherboard and PSU. My 24 pin is not a custom cable so it looks like...
When you upgrade, I’ll buy that proc from you. I had been prowling hardwareswap for a few months but hadn’t had too much luck.
Edit: I have a rampage v edition 10 mobo with Monoblock and a 6850k i’d like to upgrade.
Great looking concept. Really excited to see how your project comes to fruition. I've had a similar idea in my head but the execution has been poor.
I really like the blance of the (I really hat this term, might as well call them fedoras (sorry trillbys)) top and bottom "hats" and the...