Recent content by DASBOOT

You are correct, I was wrong, this is a co-voltage board; however, power can only be supplied to only one connector at a time, either the rear DC DIN * Connector dimension: 7.4 x 5.1mm, supports both 19V and 12V DC input, or the 2-pin molex ATX. The board is silkscreened with 19V at the molex...

You could cut this in half with an Exacto knife, carefully: 4 pin CPU. Or use this: https://www.amazon.com/Molex-Connector-Matched-18-24-Mini-Fit/dp/B074M1RZHX/ref=sr_1_3 Note the Q170T is a 19V board, and I doubt it is 12V (co-voltage) as some Thinitx boards will accept either voltage at the...

It does make a nice All-In-One.

I would suggest you contact Larry at HDPlex directly with load capability questions. https://www.aliexpress.us/item/32568087212641 [email protected]

Nice to see another AMD lover vs all the "Cruise Ship boat anchor lovers" who think Nvida needs more money added to their stock prices. Don't you just love all those connectors meting with 50 amp draw... Jun 4, 2025 — 12VHPWR and 12V-2x6 power connectors are still melting and taking graphics...

Without even building (and GaN runs much cooler than MOSFETs) "I told you so"

A 5060 low-profile graphics card typically requires a minimum of a 450W power supply, though 500W is recommended for optimal performance and to accommodate other system components. Many users won't need to upgrade their existing PSU if it's already around this capacity. I would be concerned...

You said thin. Your GPU will need undervolting, and Turbo will need to be turned off. Most Thin ITX boards have a 65-watt max at the CPU. Please review tech info on thin ITX boards here: thin itx info The 12400F has a Turbo of 117 watts. Your idea will work with the BCM board, but you will have...

Not if the thin itx board is 19 volt, some are twin voltage, 12 and 19, some are 12, but most are 19V.

I am sure you could get all those boat-anchor slow 3.5" drives in this with an itx board. By the way, all those motors will create a ton of heat and draw a lot of power. another

TETRA. OR NFC

3.3v sense to ground sense on the 10-pin. Correct me if I am wrong, please. If it is not modular, you can use 24 24-pin harness and std location for 3.3 and grd. 3. Identify the Green and Black Wires: Locate the green wire (power-on signal) and a black wire (ground) on the 24-pin connector...

Specifically, this happens when you connect the 24-pin automatically to its corresponding female Molex and only when a processor and RAM on a motherboard are installed to put a load signal to the PS. The momentary power button closes the start-up circuit, and if a load draw is sensed, ie, the...

I am IMPRESSED!!!!!

110 VOLT GaN option (alternative)