Normal
Definitely! Nope, wouldn't give me anything. Cleared CMOS, Set it to Gen4 and Gen3 respectively, triple checked it was seated correctly. Nothing.Should be an exact drop in replacement. I've modelled it from the CAD (my riser cable CAD was off so revision 2 is printing atm) so it's going to be at the exact height as the stock riser. I'll pull stuff apart tomorrow and test fit it once I have validated the dimensional accuracy of the rev2. I'll keep you posted.Edit: Rev2 aligns properly. Should have it in tomorrow.Edit2: Rev2 didn't align properly :/ Rev3 printing now.
Definitely! Nope, wouldn't give me anything. Cleared CMOS, Set it to Gen4 and Gen3 respectively, triple checked it was seated correctly. Nothing.
Should be an exact drop in replacement. I've modelled it from the CAD (my riser cable CAD was off so revision 2 is printing atm) so it's going to be at the exact height as the stock riser. I'll pull stuff apart tomorrow and test fit it once I have validated the dimensional accuracy of the rev2. I'll keep you posted.
Edit: Rev2 aligns properly. Should have it in tomorrow.
Edit2: Rev2 didn't align properly :/ Rev3 printing now.
