Normal
I've made some changes to the case in a way that don't deviate from the overall look and feel. By themselves, these changes are subtle, but altogether make it easier to produce.First, the vent areas have been updated. The top is smaller, so less to look at, but is enough still to cover the area for low profile GPUs, or APU coolers. Side vents are also diagonal to match the look. Second, the power button has been moved from the middle right to the bottom right to remove risk of interfering with any GPUs. Third, the 2 hard drive mounts went from 90 degrees to each other, to mounted in parallel. This cuts a lot of 3D printed material to be used. Fourth, width of the case has been made slighly shorter as a result.Here are the updated designs. A separate panel will be made for regular mini ITX boards (with additional input holes for DC power connections). I just need to check for measurement inconsistencies, clean up models and vector drawings to send the parts to be made. I'll be able to make 4 cases (and sell 3) for the first batch run.
I've made some changes to the case in a way that don't deviate from the overall look and feel. By themselves, these changes are subtle, but altogether make it easier to produce.
First, the vent areas have been updated. The top is smaller, so less to look at, but is enough still to cover the area for low profile GPUs, or APU coolers. Side vents are also diagonal to match the look. Second, the power button has been moved from the middle right to the bottom right to remove risk of interfering with any GPUs. Third, the 2 hard drive mounts went from 90 degrees to each other, to mounted in parallel. This cuts a lot of 3D printed material to be used. Fourth, width of the case has been made slighly shorter as a result.
Here are the updated designs. A separate panel will be made for regular mini ITX boards (with additional input holes for DC power connections). I just need to check for measurement inconsistencies, clean up models and vector drawings to send the parts to be made. I'll be able to make 4 cases (and sell 3) for the first batch run.
