Did quite alot of testing, found the stock sickleflow 140s to be quite poor performing compared to the artic P14 i had lying around. I will be putting the Arctic P14s in the stock radiator fan spot.
The BeQuiet 120s made alot of interference noise once screwed onto the bottom panel, they really need an air gap much like the 160mm fans, i have opted for using the sickleflow fans for the bottom intake 140s, With the metal stiffing bend it gives just the right amount of clearance.
To assist and steady the graphics card, ill be drilling and screwing a hole into the frame at the lower 'feet' to help stop bigger cards from sagging. (note this is not the intended card, im planning to use my inno 3080 for the time being and get the case ready for 7900xtx/4090
The 140s in the bottom are sitting too tight next to the power cable, ill mod the fans down a bit to help with clearance, trying to think of a way to bolt them in.
Silverstone 160mm in position, testing adding air gap. still plenty of room to clear a 2 slot gfx card
