Reply to thread

Message

A couple updates to the design and now I have a top piece that I think is ready to print and try out. There are clips and notches to keep the screen in position, but to keep it from falling inwards, as well as the controls, I need to model the middle piece further which will connect using screws and tabs on the sides.

[QUOTE="CC Ricers, post: 254428, member: 130"] A couple updates to the design and now I have a top piece that I think is ready to print and try out. There are clips and notches to keep the screen in position, but to keep it from falling inwards, as well as the controls, I need to model the middle piece further which will connect using screws and tabs on the sides. [IMG width="684px"]https://i.imgur.com/J1hao6D.png[/IMG] [/QUOTE]

Verification