Reply to thread

Message

Why not replace the "shielding PCB" on the back of the assembly with a 3D printed piece? it would only have to be 1mm thick there, making the assembly 0.4mm thicker, but it could slide over the PCB from the side after the wires and pins are soldered in place and trimmed. It would make the assembly a little bit taller, unfortunately.

[QUOTE="iFreilicht, post: 29531, member: 15"] Why not replace the "shielding PCB" on the back of the assembly with a 3D printed piece? it would only have to be 1mm thick there, making the assembly 0.4mm thicker, but it could slide over the PCB from the side after the wires and pins are soldered in place and trimmed. It would make the assembly a little bit taller, unfortunately. [/QUOTE]

Verification